![]() Go to the plus button on the model number and enter in the verification code that is on the attached monitor in the same screen where the QR code is.It will show the NVR or DVR on your device. Just like you did with the camera, go to the Circle in the top right and scan the QR code that is displayed on the attached monitor.You will need your phone or tablet at this time and you will need to be logged into the Cloud P2P account. On the same page you will see Platform Access, make sure that enable is checked.Toward the bottom you will need to change the Preferred DNS Server to 8.8.8.8 and the Alternate DNS Server to 8.8.4.4. ![]() Now that you are logged in, go to Configuration and select Network on the left side.Enter your username and password for the NVR or DVR. On your attached monitor you will need to right click and select Menu.Initial Setup for your H Series NVR / DVR If you have not and you need assistance please follow this link to our helpful guide: It will be the same process as adding a camera but this time you will need to have a monitor attached to the NVR or DVR.Īt this point we are assuming that you have already set up your NVR or DVR. Now that you know how simple it is to set up your camera on the Cloud P2P, let’s add an NVR or DVR. Step Five Step Six fi Step Seven Cloud P2P With NVR / DVR New Device will show up with a nine digit number and below that you will see your camera model. Scan the QR code that is displayed on your computer screen.In the account you will go to the circle in the top right to access the QR Code Scanner.If Enable is not checked for Platform Access, click that and select save.Īdding the Camera to the Cloud P2P Account In Advanced Settings go to Platform Access and make sure your phone or tablet is ready and logged into the Cloud P2P account that was created in the previous section.Save that and go to Advanced Settings under Network.In the "Preferred DNS Server" type "8.8.8.8," and in "Alternate DNS Server" type "8.8.4.4." At the bottom of the Network tab, you will find Preferred and Alternate DNS Server.Go to the Configuration menu on the camera's interface, then to the Network tab.If you are in need of the firmware to update your camera please check our website for the latest firmware.Īfter this, your camera should be up to date and you can now add the camera to Cloud P2P by following these steps: You can locate the firmware under configuration, head over to system then system settings. Your camera will need Firmware Version 5.4.1 or above in order for you to access the camera on your Cloud P2P account. For this demonstration I am using camera model NSC-204-BT.īefore you can add the camera to your Cloud P2P account you will need to check and make sure you have the correct firmware. We’re going to start off with using Cloud P2P on an IP camera. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |